Skip to content

Games on the Creator 5

The Creator 5 runs on an Ingenic X2600, a low-power embedded chip that's very slow by modern standards. That's what makes these ports a feat: real games running on hardware that was never meant to do much more than drive a print UI.

These are community-built ports you can install on OpenCreator CFW.

Games are not part of printing

Games run on the printer's application processor, separate from the motion firmware. They don't affect printing, but don't run them while a print is in progress. The touchscreen will be used as the display and actively shares resources.

DOOM

The classic 1993 shooter, running on the Creator 5's touchscreen with on-screen controls (D-pad, action buttons, and the status bar).

DOOM running on the Creator 5 with on-screen touch controls

DOOM is driven by the open WAD asset files, so you can also load custom levels and total conversions.

DOOM WADs

DOOM's game data lives in .wad files. The engine is free; you supply a WAD:

  • Registered DOOM.WAD / DOOM2.WAD - from a retail copy you own.
  • Community WADs - free fan-made levels and total conversions (many are standalone and need no retail files, includes FreeDOOM).

Drop the WAD onto the printer and point the port at it. Touch controls work the same as the stock episode.

Sonic Mania

Sonic Mania, the 2017 & 2018 platformer by SEGA, Christian Whitehead, PagodaWest Games and Headcannon, running at full speed during 2D sections, and almost full speed during 3D sections to get emeralds. Fully completable from start to finish. Using RSDK 5U.

Sonic Mania running on the Creator 5

Installing

Games are installed as git repositories. Some may not be available, and need to be asked for.

Notes

  • These are made by OpenCreator, but not encouraged. Expect rough edges.
  • Touch input is mapped to on-screen buttons, and some games may support gamepad input or keyboard.
  • Performance is limited by the slow embedded processor, and may encounter slowdown.