OpenCreator CFW¶
OpenCreator full custom firmware, or CFW, is the deeper Creator 5 integration effort. It aims to make the printer's host software, MCU behavior, toolchanging, and configuration maintainable as one community-developed stack. To gain is more features and more stable software overall compared to stock. CFW is in public alpha; get the latest release. The mostly stock alternative is OpenCreator Legacy.
The work is split between kalico for Klipper and MCU integration (it replaces klipper-c5, which is archived), and opencreator-fs for printer files, configuration, and installation helpers.
What the newer path aims to support¶
| Full custom firmware area | Goal | Status |
|---|---|---|
| Base software | Maintain Creator 5 stock behavior in a community-developed Klipper host and MCU stack. | Finished |
| Installation and updates | Provide a tested CFW installation. | Finished |
| Tool selection | Configure T0 to T3 pickup, docking, and safety in host-side modules and macros. | Finished |
| Filament control | Integrate AFC standalone for toolchanger filament mapping, loading, and runout handling. | Finished |
| ACE Pro | Use an ACE Pro as another filament system, each slot feeding its own head, with auto feed and auto load. | Finished |
| ACE Pro multiplexing | Feed several ACE slots into one head and swap between them. | Planned |
| Web and touchscreen | Allow for switching filaments on the web. | Partial |
| Raspberry Pi host | Use USB gadget mode to tunnel Klipper communication from a Raspberry Pi running the Klipper host to the printer. | Testing |
| Extend stock features | Better VFA testing, stallguard and other similar improvements to software | Partial |
To see more features that are directly implemented in detail look at CFW Features.
These are goals, and not all of them are finished. The ACE Pro works with auto feed and auto load, multiplexing is in the planning stages, and the Raspberry Pi tunnel is in testing (see OpenCreator for SBC).
Gadget mode Klipper / RPI Klipper is very close to what AnyCubic's modding scene calls Tunneled Vanilla Klipper and a lot of inital insperation was taken to go this route over direct MCU soldering, as it may not be possible on this board, as there has been no direct way (yet) to solder and allow USB passthrough for the MCUs.